Simco Fmx002 | Manual Full [exclusive]

: Point the sensor toward an uncharged (earthed) area and press the POWER button.

| Problem | Likely Cause | Solution (from manual) | |---|---|---| | No display | Dead battery, or polarity reversed | Replace battery, check snap connector | | Erratic readings | Dirty sensor aperture | Clean gently with isopropyl alcohol and a cotton swab | | Cannot zero to 000 | Residual charge on operator | Touch a grounded metal object to discharge yourself | | Stuck at 000 but surface is charged | Distance too far | Move to 25mm (LEDs merge) | | Over-range (OVR) on a low static item | Wrong range selected | Auto-ranging should work; if not, reset device (remove battery for 10 sec) | simco fmx002 manual full

Have questions about your FMX-002 not covered here? Leave a comment or contact an authorized SIMCO distributor. And remember: when in doubt, consult the before taking any critical measurement. : Point the sensor toward an uncharged (earthed)